Have you ever wondered how to wire a four wheeler ATV starter solenoid? If so, you’re in luck. This article will provide you with the information you need to get the job done. We’ll cover what a starter solenoid is, how it works, and how to wire it correctly. Let’s dive in!
A starter solenoid is a switch-like device that is used to control the starter motor of an engine. It is usually located near the battery and consists of two terminals, a large one and a small one. When the ignition switch is turned on, the large terminal receives power from the battery and sends it to the starter motor. The small terminal then receives power from the starter motor and sends it to the starter relay, which then sends the power to the starter motor.
The wiring diagram of a four wheeler ATV starter solenoid can vary depending on the make and model of the ATV. Generally, the wiring diagram will show the location of the terminals, the colors of the wires, and the wiring connections. It is important to follow the wiring diagram closely for proper installation.
Before beginning the wiring process, make sure the battery is disconnected and the ignition switch is off. The first step is to connect the two terminals of the starter solenoid to the battery. The large terminal should be connected to the positive terminal on the battery, and the small terminal should be connected to the negative terminal on the battery.
Next, you will need to connect the starter motor to the starter solenoid. Connect the positive terminal of the starter motor to the large terminal on the starter solenoid. Then, connect the negative terminal of the starter motor to the small terminal of the starter solenoid.
The next step is to connect the starter relay to the starter solenoid. Connect the positive terminal of the starter relay to the small terminal of the starter solenoid, and the negative terminal of the starter relay to the large terminal of the starter solenoid.
Finally, you will need to connect the ignition switch to the starter solenoid. Connect the positive terminal of the ignition switch to the large terminal of the starter solenoid, and the negative terminal of the ignition switch to the small terminal of the starter solenoid.
Now you have successfully wired your four wheeler ATV starter solenoid! To ensure that the wiring was done correctly, it is important to test the connections before turning the ignition switch on. If the connections are good, then you’re ready to start your ATV.
It is important to note that the wiring diagram of a four wheeler ATV starter solenoid can vary depending on the make and model of the ATV. It is always best to consult the owner’s manual before performing any wiring work.
In conclusion, wiring a four wheeler ATV starter solenoid is not a difficult task. With a little patience and the right tools, you can easily get the job done. Remember to always consult the owner’s manual before beginning any wiring work and be sure to test the connections before turning the ignition switch on. Good luck!
